2023 Updated Verified Pass H12-211 Exam - Real Questions and Answers
Dumps Moneyack Guarantee - H12-211 Dumps Approved Dumps
Huawei H12-211 certification exam is an excellent way for IT professionals to validate their skills and knowledge in data communication. Huawei Certified Datacom Associate-Huawei Networking Technology and Device (HCDA-HNTD) certification can help individuals stand out in a competitive job market and increase their chances of landing a job in the IT industry. H12-211 exam is available in English and Chinese languages and can be taken at any authorized Huawei testing center or online. The Huawei Certified Datacom Associate program is an excellent opportunity for IT professionals to develop their skills and advance their careers.
The HCDA-HNTD certification exam covers a wide range of topics, including network fundamentals, LAN technologies, WAN technologies, routing technologies, switching technologies, network security, and network management. H12-211 exam is designed to test the ability to implement and maintain Huawei data communication solutions in a real-world environment.
NEW QUESTION # 75
Refer to the configuration output. Which following statements are correct? (Multiple choice)
- A. Prior to changing the link-type to access, the command "undo port trunk allow-pass vlan 2 to 4096" must be used to renew the default configurations.
- B. Prior to changing the link-type to access, the command "undo port trunk allow-pass vlan all" must be used to renew the default configurations.
- C. VLAN 1 can pass over interface Gigabit Ethernet 0/0/1.
- D. VLAN 1 cannot pass over interface Gigabit Ethernet 0/0/1.
Answer: A,D
NEW QUESTION # 76
In RSTP mode, interfaces in the Discarding state discard received data frames but maintain the MAC address table based on received data frames.
- A. TRUE
- B. FALSE
Answer: B
NEW QUESTION # 77
Which of the following are the stable states of OSPF neighbor relationships? (Multiple Choice)
- A. 2-way
- B. Full
- C. Down
- D. Attempt
Answer: A,B,C
NEW QUESTION # 78
NAPT which elements can be converted
- A. Only the MAC address
- B. MAC address + port number
- C. only the IP address
- D. IP address + port number
Answer: D
NEW QUESTION # 79
Judgments: When two routers directly connected through the ATM interface or through the WDM (Wavelength Division Multiplexing) connections should be configured to use one end of the main clock mode, the other end from the clock mode. When and SDH / SONET equipment are connected, the router should be configured from the clock.
- A. False
- B. True
Answer: B
NEW QUESTION # 80
Which of the following commands can be used to query the configuration information of the OSPF protocol?
(Multiple Choice)
- A. display ospf peer
- B. In OSPF protocol view display this
- C. dis ip routing-table
- D. display current-configuration
Answer: B,D
NEW QUESTION # 81
When the first packet received in some field values are not correct, it discards the datagram to the source to send ICMP () message.
- A. Parameter problem
- B. Redirect
- C. does not reach the destination station
- D. source quench
Answer: A
NEW QUESTION # 82
The following description of the OSPF area is correct (). (multiple choice)
- A. All networks should be announced in zone 0
- B. Configure the ip address of the loopback interface of the router before configuring the OSPF area.
- C. The number of the backbone area cannot be 2
- D. The area number range is from 0.0.0.0 to 255.255.255.255
Answer: C,D
NEW QUESTION # 83
Router 1 routing table output information is as follows: which is correct? (Multiple choice)
- A. The IP address of the Ethernet 0/0/0 interface on the router is 10.0.12.1.
- B. There is a dynamic routing protocol in the routing table.
- C. The mask length of the IP address of the Ethernet0/0 interface on the router is 24 bits.
- D. There are two dynamic routing protocols in the routing table.
Answer: A,C,D
NEW QUESTION # 84
Which of the following statements are correct about TTL field in IP packet? (Choose two)
<choice ident="A">
<choice ident="B">
<choice ident="C">
<choice ident="D">
- A. Normally, it's impossible for a router to receive a packet whose TTL is zero.
- B. The main purpose of TTL is to prevent IP packets from circulating endlessly in a network which can consume a lot of bandwidth.
- C. TTL value will be decremented as a packet is passed through the network devices such as hub, LAN switch and router.
- D. The maximum value of TTL is 65535.
Answer: A,B
NEW QUESTION # 85
Which of the following multicast addresses Is used in OSPFv3 to represent all routers?
- A. FF02::5
- B. FF02::6
- C. FF02::7
- D. FF02:;8
Answer: A
NEW QUESTION # 86
For multiple paths to the same destination network, the router needs to select by comparing the size of the Cost value_ If the value of the Cost is the same, then select according to the size of the Preference value.
- A. True
- B. False
Answer: B
NEW QUESTION # 87
As Shown in the figure, host A and host B cannot communicate with each other?
- A. TRUE
- B. FALSE
Answer: A
NEW QUESTION # 88
The administrator wishes to configure OSPF on a router in the network, however the router has no loopback interface. Which value will be used as the router ID
- A. The highest IP address of the router's interface
- B. The priority value of the router
- C. The lowest IP address of the router's active interface
- D. The IP address of the management interface
Answer: A
NEW QUESTION # 89
An AR2200 router is required to be configured from scratch. Which step are needed to achieve this?
- A. Reset the saved configuration
- B. Assign the configuration file to be used at next startup
- C. Clear the current configuration
- D. Reboot the AR2200
Answer: A,D
NEW QUESTION # 90
PPP state transition diagram which includes the following stages
- A. Network
- B. Establish
- C. Authenticate
- D. Idle
Answer: A,B,C,D
NEW QUESTION # 91
As shown in the network, the configuration information of Router A is as follows. Which of the following statement is wrong?
- A. The host with the source IP address of 200.0.12.8 cannot access the Internet.
- B. The host with the source FP address of 200.0.12.2 cannot access the Internet.
- C. The host with the source EP address of 200.0.12.6 cannot access the Internet.
- D. The host with the source IP address of 200.0.12.4 cannot access the Internet.
Answer: A
NEW QUESTION # 92
A router learns routes to the same destination address through RIP, OSPF, and static routes. By default, VRP will be the most Which routing protocol does the terminal choose to learn?
- A. The routes learned by the three protocols are selected.
- B. RIP
- C. Static routing
- D. OSPF
Answer: D
NEW QUESTION # 93
IPv6 can also be called:
- A. NextIP
- B. RIPng
- C. IPng
- D. IP+
Answer: C
NEW QUESTION # 94
......
Huawei H12-211 exam is a certification exam offered by Huawei Technologies Co. Ltd. H12-211 exam is designed to test the skills and knowledge of individuals in the field of data communication and networking. It aims to evaluate the ability of candidates to design, deploy, and manage small to medium-sized networks using Huawei devices and technologies. Huawei Certified Datacom Associate-Huawei Networking Technology and Device (HCDA-HNTD) certification provides a solid foundation for network engineers and administrators to advance their careers in the ICT industry.
Updated PDF (New 2023) Actual Huawei H12-211 Exam Questions: https://www.dumpstests.com/H12-211-latest-test-dumps.html