Pass Cisco 300-510 Actual Free Exam Q&As Updated Dump Nov 21, 2024
Latest 300-510 Actual Free Exam Updated 253 Questions
To be eligible for the Cisco 300-510 exam, candidates should have a thorough understanding of routing protocols such as OSPF, BGP, and IS-IS, as well as experience in implementing VPN technologies such as MPLS and DMVPN. They should also have knowledge of network automation and programmability using tools such as Python and Ansible. Additionally, candidates should have experience working in a service provider environment and be familiar with the challenges and requirements of implementing advanced routing solutions in such environments.
NEW QUESTION # 98
Drag and Drop Question
Drag and drop the attributes for the BGP route selection on the left into the correct order on the right. Not all options are used.
Answer:
Explanation:
Explanation:
https://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/13753-25.html
NEW QUESTION # 99
Refer to the exhibit.
Refer to the exhibit There is a BGP traffic path issue between Customer-1 and Customer-2 Users from Customer-2 have reported file transfer issues High utilization on the path between both customers causes many packet drops. Which configuration resolves the issue?
- A. Option D
- B. Option A
- C. Option B
- D. Option C
Answer: C
NEW QUESTION # 100
Refer to the exhibit.
CE1 is the gateway router into the provider network via PE1. A network operator must inject a default route into OSPF area 0. All devices inside area 0 must be able to reach PE1. Which configuration achieves this goal?
- A. Option B
- B. Option D
- C. Option A
- D. Option C
Answer: D
NEW QUESTION # 101
Refer to the exhibit.
Routers R1, R2. R3, and R4 have been configured to run OSPF. and router R5 is running EIGRP Traffic from R1 to R5 is expected to pass via R4. but OSPF routing has calculated the best path via R3. Which action corrects the problem?
- A. Configure R3 to use metric-type 1 with a higher metric than R4.
- B. Configure R1 with a static route to the R5 networks and set R5 as the next hop.
- C. Reconfigure R1 in Area 0.
- D. Change the metric-type value on R3 to 2.
Answer: D
NEW QUESTION # 102
Refer to the exhibit.
Refer to the exhibit. A network engineer commissioned Router 1, which connects lo Router 2 and Router 5 Router 1 participates in IS-IS routing with other routers, but it is not used for transit traffic. Traffic from Router 2 to Router 5 is expected to travel via Router 1 but the traffic is travelog via Router 3 and Router 4 Which action reserves this problem?
- A. Add the overload bit on Router 5
- B. Remove the overload bit on Router 1.
- C. Add hello padding on Router 1
- D. Remove the hello padding on Router 5
Answer: B
NEW QUESTION # 103
Refer to the exhibit.
XR1 and XR2 are sending the prefix 10.11.11.0/24 to XR3. A configured policy on XR1 is incorrectly prepending AS path 11 11 12 12 onto this prefix. A network operator wants to add a policy onto XR3 that will not allow the falsely prepending prefix from being installed. Which policy configuration applied to the XR3 neighbor configuration for XR1 can accomplish this requirement without impact to other or future received routes?
- A. Option D
- B. Option B
- C. Option A
- D. Option C
Answer: A
NEW QUESTION # 104
What are two features of dual-stack? (Choose two.)
- A. t requires tunneling IPv6 traffic over an IPv4 infrastructure.
- B. t securely routes and tunnels traffic between separate sites over the Internet.
- C. t supports IPv4 and IPv6 traffic on the same infrastructure.
- D. t is implemented without excessive processing power.
- E. t allows an engineer to stack multiple Layer 2 switches to serve as a single switching unit.
Answer: C,D
NEW QUESTION # 105
Refer to the exhibit. Customer traffic from the branch site to the hub is experiencing packet drops.
The engineer verified that:
- Customer traffic from the hub is able to reach the branch site.
- The connection between PE1 and PE2 is working normally.
- Routers P1 and P2 are able to ping devices on the hub site.
Which action resolves the issue?
- A. Advertise the VPNv4 routes of the branch site in CE2.
- B. Redistribute the CE2 OSPF routes in the PE2 VRF.
- C. Redistribute the CE1 OSPF routes in the PE1 VRF.
- D. Advertise the VPNv4 routes of the hub in CE1.
Answer: D
NEW QUESTION # 106
Refer to the exhibit. The green policy is designed with low delay, and the pink policy is designed with low cost. What is the next hop for node A on its way to node D, with the objective of achieving a low delay?
- A. 192. 168.1.2
- B. 192.168.1.6
- C. 192.168.3.6
- D. 192.168.3.2
Answer: A
NEW QUESTION # 107
Refer to the exhibit.
What is the effect of this configuration?
- A. It sets the hold timer to 30 seconds and the keepalive timer to 240 seconds.
- B. It sets the keepalive timer to 30 seconds and the hold timer to 240 seconds.
- C. It sets the hold timer to 30 milliseconds and the keepalive timer to 240 milliseconds.
- D. It sets the keepalive timer to 30 milliseconds and the hold timer to 240 milliseconds.
Answer: B
NEW QUESTION # 108
Refer to the exhibit.
An engineer is addressing an IS-IS design issue which is running within the topology. All links are running on FastEthernet, except the link between R5 and R4, which is Gigabit Ethernet. Which statement about the design is true?
- A. All links have equal cost if the default metric is used
- B. R5 prefers to use R4 as the next hop for all routes
- C. R4 prefer to reach R5 using R1 as the next hop
- D. R1 prefer to use R5 as the next hop to reach R4
Answer: A
NEW QUESTION # 109
Refer to the exhibit.
A network operator must inject a Level 1 route from XR2 (10.16.16.0/24) into the ISIS topology. Which configuration allows the injection in a way that XR3 and XR1 have a valid and working route for 10.16.16.0/24?
- A. Option B
- B. Option D
- C. Option A
- D. Option C
Answer: D
NEW QUESTION # 110
Refer to the exhibit. A network operator is working to deploy a Unified BGP design and allow it to be available only in selected markets and services in the future. The label allocation is not functioning as desired. Which action will fix the issue?
- A. Reconfigure the route-policy ALL_LABELS to pass.
- B. Remove the allocate-labels command.
- C. Reconfigure the route-policy ALL_LABELS to match all after the drop.
- D. Remove the route policy and only configure "allocate-label".
Answer: A
NEW QUESTION # 111
An engineer is troubleshooting a connectivity issue across the MPLS network and is verifying the forwarding behavior of packets. Which table does the engineer look at to verify the forwarding behavior of an IP packet as it enters the MPLS network at the ingress LSR?
- A. FIB
- B. LIB
- C. LFIB
- D. RIB
Answer: C
Explanation:
https://community.cisco.com/t5/image/serverpage/image-id/44142iC3B9032F415B1395?v=v2
NEW QUESTION # 112
Refer to the exhibit.
After troubleshooting an OSPF adjacency issue, routers 1, 2, and 3 have formed OSPF neighbor relationships. Which statement about the configuration is true?
- A. Router 2 uses router 1 as the next hop for 192.168.0.0/24
- B. Router 2 receives a Type 5 LSAs from router 1 for its connected subnets
- C. Router 2 uses router 3 as the next hop for 192.168.0.0/24
- D. Router 2 receives a Type 7 LSAs from router 3 for its connected subnets
Answer: A
Explanation:
From IOS 15.1(2)S onwards, Cisco uses the OSPF path selection order is O > O IA > N1 > E1 > N2 > E2 https://www.cisco.com/c/en/us/support/docs/ip/open-shortest-path-first-ospf/212608-ospf-external-path-selection-external-t.html
NEW QUESTION # 113
An engineer is working to implement segment routing protocol on the customer's core network. Which step should the engineer take before the segment routing is enabled and is running with BGP?
- A. Explicit-null must be configured for all neighbors.
- B. MPLS must be configured.
- C. Segment routing must be configured with EIGRP.
- D. Segment routing must be configured with ISIS.
Answer: B
NEW QUESTION # 114
Refer to the exhibit. Which tree does multicast traffic follow?
- A. MDT voice
- B. source tree
- C. shared tree
- D. MDT default
Answer: D
NEW QUESTION # 115
In a PIM-SM environment, which mechanism determines the traffic that a receiver receives?
- A. The receiver explicitly requests its desired traffic from the RP on the shared tree.
- B. The receiver explicitly requests traffic from a single source, which responds by forwarding all traffic.
- C. The RP on the shared tree floods traffic out of all PIM configured interfaces.
- D. The receiver explicitly requests traffic from each desired source, which responds by sending all traffic.
Answer: D
NEW QUESTION # 116
Refer to the exhibit.
CE1 is the gateway router into the provider network via PE1. A network operator must inject a default route into OSPF area 0. All devices inside area 0 must be able to reach PE1. Which configuration achieves this goal?
- A. Option B
- B. Option D
- C. Option A
- D. Option C
Answer: D
Explanation:
Reference:
https://www.cisco.com/c/en/us/support/docs/ip/open-shortest-path-first-ospf/47868-ospfdb9.html
NEW QUESTION # 117
Refer to the exhibit. OSPF is running in the core of a company. Router RA is running EIGRP.
After the company acquired an additional office, an engineering team connected the two networks from router RA to router R1. OSPF and EIGRP have been mutually redistributed on R1, but the team cannot view the routes on R3. Which action must the team take to resolve the issue?
- A. Create a virtual link between R1 and R2.
- B. Disable stub routing in Area 1.
- C. Configure the routers in Area 2 to be in Area 0.
- D. Redistribute connected routes on R3.
Answer: B
NEW QUESTION # 118
Refer to the exhibit.
A network operator wants to expand the segment routing global block in upcoming maintenance. The operator must ensure that the changes to the segment routing global block have no adverse impacts on the prefix-sid associated with the loopback0 interface used within the OSPF domain.
Which command can the operator use to enforce R2 to have a strict prefix-sid assignment to loopback0?
- A. Option B
- B. Option D
- C. Option A
- D. Option C
Answer: D
NEW QUESTION # 119
......
Online Questions - Valid Practice 300-510 Exam Dumps Test Questions: https://www.dumpstests.com/300-510-latest-test-dumps.html
100% Real 300-510 dumps - Brilliant 300-510 Exam Questions PDF: https://drive.google.com/open?id=1kQ3Mz_IWb_0C_QHR1Yz-rgt2mXyMUtXj